Cleaning And Maintenance; Troubleshooting - ElectrIQ EGH20AWB User Manual

MAINTENANCE
CLEANING AND STORAGE
ATTENTION: Please shut off the unit and unplug from the mains before cleaning or
performing any maintenance.
Cleaning the surface
Clean the heater with a duster or a soft wet cloth.
Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause
irreversible damage. Make sure no water enters the control panel or gaps in the casing.
Do not run the unit until completely dry.
Place the heater in its original box or cover to protect it from dust when not in use.
Store it in a cool, dry place.

TROUBLESHOOTING

Do not repair or disassemble the unit by yourself; unauthorized repair attempts will invalidate
the warranty and may cause bodily harm.
Issue Possible Reason
No power 1. The power cord is unconnected
2. There is no power from the socket
3. The power switch on the rear of the unit
is turned off.
Odour 1. New unit. When the unit is used for the
emission first time the fan motor may produce an
from the odour which will dissipate within a week of
unit use
Strong 1. The Unit is not placed on a flat surface
vibrations 2. The unit may be damaged
and noise
If the above solutions do not resolve the problem please contact the service centre.
DECLARATION OF CONFORMITY
Hereby, electriQ declares that this heater follows Directive 2014/53/EU. The full text of the
EU declaration of conformity is available at the following internet address:
https://www.electriQ.co.uk/content/declaration-of-conformity
Solution
1. Connect the power cord
2. Check socket is turned on
3. Ensure the power switch on
the rear of the unit is in the on
position
1. No action required
1. Place on a flat surface. May
put
underneath
2. If the heater is damaged
discontinue use and contact the
service centre.
Page 21 of 23
an anti-vibration mat