Setting The Jumpers - IBASE Technology MBB-1000AF Series User Manual

2.2

Setting the Jumpers

Set up and configure your MBB-1000AF by using jumpers for various
settings and features according to your needs and applications. Contact
your supplier if you have doubts about the best configuration for your use.
2.2.1 How to Set Jumpers
Jumpers are short-length conductors consisting of several metal pins with a
non-conductive base mounted on the circuit board. Jumper caps are used
to have the functions and features enabled or disabled. If a jumper has 3
pins, you can connect either PIN1 to PIN2 or PIN2 to PIN3 by shorting.
Pin# 1
A 3-pin jumper
Refer to the illustration below to set jumpers.
Pin closed
Open
1-2
2-3
When two pins of a jumper are encased in a jumper cap, this jumper is
closed, i.e., turned On.
When a jumper cap is removed from two jumper pins, this jumper is open,
i.e., turned Off.
MBB-100AF User's Manual
3
2
Oblique view
2
Hardware Configuration
A jumper cap
Illustration
1 2 3
1 2 3
1 2 3
13