Setting The Jumpers - IBASE Technology IB818 User Manual

2.2 Setting the Jumpers

Configure your IB818F by using jumpers to enable the features that you need
based on your applications. Contact your supplier if you have doubts about
the best configuration or settings.
2.2.1 How to Set Jumpers
Jumpers are short-length conductors consisting of several metal pins with a
base mounted on the circuit board. Jumper caps are placed (or removed) on
the pins to enable or disable functions or features. If a jumper has 3 pins, you
can connect Pin 1 with Pin 2 or Pin 2 with Pin 3 by shorting the jumper.
Pin# 1
A 3-pin jumper
Refer to the illustration below to set jumpers.
Pins Oblique view
Open
1-2
2-3
When two pins of a jumper are encased in a jumper cap, this jumper is
closed, i.e. turned On.
When a jumper cap is removed from two jumper pins, this jumper is open,
i.e. turned Off.
IB818F User's Manual
3
2
Illustration
1 2 3
1 2 3
1 2 3
2
Hardware Configuration
A jumper cap
13