Set-Up Instruction - Honda HRJ216K2 Manual

Unpacking
Remove all protective cardboards from the mower, including the piece
around the handlebar.
Grass Bag Installation
Refer to page 61
Handlebar Setup
1. Remove the locking knobs from the handlebar mounting section of
the cutter housing.
2. Set the lower section of the handlebar to the handlebar mounting
section of the cutter housing enough so you can raise the handlebar
into the normal position.
3. Loosely install the washers and locking knobs.
4. Raise the handlebar in place.
5. Tighten the locking knobs securely.
6. Install the rope guide to the handlebar tighten the flange nut and
lock nut securely.
7. Remove the wire bands from the cables.
8. Install the air cleaner hose to the air cleaner cover and throttle lever
cover (PWHH and TWHH Types).
AIR CLEANER HOSE
(PWHH and TWHH Types)
for grass bag installation.
ROPE GUIDE
10.

SET-UP INSTRUCTION

LOCK NUT
FLANGE NUT
LOCKING KNOB (2)
WIRE BANDS (5)
HANDLEBAR
WASHER (2)
67