Avc Receiver Installation - Horizon Hobby Spektrum Smart Technology SR6200A Instruction Manual

NOTICE: Do not connect a dedicated receiver battery to the receiver along
with an ESC (with a BEC, a feature which most ESCs include). When an ESC
is powered on it provides the receiver with regulated power from the main
battery through the throttle connection. The ESC, battery and/or receiver may
be damaged if the receiver is also connected to a dedicated receiver battery.
This does not apply to an ESC without a BEC.

AVC RECEIVER INSTALLATION

Install the SR6200A receiver in the vehicle before binding the transmitter and
receiver. The receiver can be mounted completely flat (servo ports and bind
button facing up) or completely perpendicular on its side. When binding the
receiver, the AVC system automatically detects the orientation of the receiver.
If the receiver is angled, AVC technology may not function properly. If the
orientation of the receiver is modified after binding, you must rebind for AVC
technology to function properly.
You may mount the receiver on any of its six sides, and it does not matter
which direction the receiver is pointed. The receiver doesn't even need to be
square with the vehicle, as long as it is flat and level.
IMPORTANT: Do not use hook and loop tape to install the SR6200A receiver.
Using hook and loop tape will effect the performance of the AVC system.
ANTENNA INSTALLATION
The SR6200A receiver has a coaxial style antenna. Position the antenna
vertically and away from the vehicle in an antenna tube. Make sure the tip of
the antenna is as high as possible to maximize the signal strength.
NOTICE: Do not cut, kink, or modify the antenna. Damage to the coaxial
portion of the antenna will reduce the performance of the antenna.
Shortening or cutting off the 31mm tip will reduce the range to a small
fraction of what it should be.
Mount the receiver flat,
two possibilities are shown here
Active portion
of antenna
EN
5