Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for D.T.Systems NO BARK TRAINER
Summary of Contents for D.T.Systems NO BARK TRAINER
- Page 1 1145DT NO BARK TRAINER INSTRUCTION MANUAL D.T. SYSTEMS, INC.
-
Page 2: Table Of Contents
TABLE OF CONTENTS Introduction ..........3 • Features ............4 • Package Contents ......... 4 • Parts & Functions ......... 5 • Choosing the Correct • Electrodes and Sensors......... 6 Adjusting and Positioning Your Collar ..7 • Operation ............8 •... -
Page 3: Introduction
It is recommended that you fully read and understand this entire owner’s manual prior to operating your 1145DT No Bark Trainer. If you have any questions or do not fully understand any part of this manual, or the product’s features or operation please contact our customer service department at the phone number or address on the back of this manual. -
Page 4: Features
FEATURES The newly redesigned 1145DT No Bark Training System features: • Completely Digital Micro-processor System. • Adjustable Collar fits small to large dogs. • Replaceable 6 Volt Battery • System delivers 1/2 second corrective stimulation. • Automatic three-second safety delay. •... -
Page 5: Parts & Functions
PARTS & FUNCTIONS • The collar belt is adjustable from approximately 7” to approximately 21”. • The round circle on the clip with D.T.S. imprinted on it is a magnet for turning the unit ON/OFF and changing intensity levels. (You can also use the key ring magnet.) •... -
Page 6: Choosing The Correct
CHOOSING THE CORRECT ELECTRODES AND SENSORS Choosing the proper electrode and sensor length is vital to the proper operation of the unit. Electrodes and sensors should be long enough to make good contact with the dog’s skin without being so long as to interfere with the dog’s normal breathing. -
Page 7: Adjusting And Positioning Your Collar
ADJUSTING & POSITIONING YOUR COLLAR FOR PROPER FIT Proper collar tightness and position are very important to insure safety and correct functioning every time you use the collar. • All electronic collars need to be very snug to work properly. They must be just tight enough to allow the electrodes and the sensor to make good skin contact. -
Page 8: Operation
OPERATING THE 1145DT Turning the 1145DT ON & OFF: Turning the Unit ON: • Touch either magnet to the White Dot on the side of the 1145DT collar box for approximately one half second until the number 0 flashes briefly on the LED Display. •... -
Page 9: Changing The Battery
CHANGING THE BATTERY NOTE Use only 6 Volt Alkaline or Lithium Battery. (Lithium will last longer) Follow these steps to change the battery on the 1145DT: 1) Use a coin or screw driver to open the battery compartment cap by turning it counter-clockwise. 2) Remove the old battery. -
Page 10: Testing
TESTING 1. Place the two red wires from the Test Light onto the electrodes (as shown in the picture above). 2. Turn the unit ON using either magnet. 3. Slide the bottom of the test light (the serrated edge) across the top of the sensor. -
Page 11: Important Safety Notes
Therefore never leave the unit on your dog while unsupervised. • Your 1145DT No Bark Trainer is a very valuable tool if used correctly. Therefore it is extremely important that you completely understand all functions of the collar and how to properly train with it before placing it on your dog. -
Page 12: Contact Information
D.T. SYSTEMS, INC. 2872 Walnut Hill Lane Dallas, Texas 75229 Tel: (214) 350-9446 Fax: (214) 350-7847 www.dtsystems.com customerservice@dtsystems.com ONLINE RETAILER Hickory Hollow Upland Sporting Gear www.everythingupland.com...