INTRODUCTION Congratulations and Thank you for purchasing the 1125DT No Bark Training System. This collar is one of the best and most advanced No Bark Trainers in the World. The 1125DT has been specially designed for training your dog and for preventing excessive barking by automatically sending out an electrical stimulation whenever problem barking occurs.
Data Memory System saves last used intensity setting. Completely Waterproof. PACKAGE CONTENTS 1125DT No Bark Collar - Size: 2.3” X 1.6” X 1.1” Weight: 4 oz. 1/2” Electrodes & 1/2” Sensor 3/4” Electrodes & 3/4” Sensor Key-Ring Magnet Test Light...
PARTS & FUNCTIONS The collar belt is adjustable from approximately 7” to approximately 21”. The round circle on the clip with D.T.S. imprinted on it is a magnet for turning the unit ON/OFF and changing intensity levels. (You can also use the key ring magnet.) ...
CHOOSING THE CORRECT ELECTRODES AND SENSORS Choosing the proper electrode and sensor length is vital to the proper operation of the unit. Electrodes and sensors should be long enough to make good contact with the dog’s skin without being so long as to interfere with the dog’s normal breathing.
ADJUSTING & POSITIONING YOUR COLLAR FOR PROPER FIT Proper collar tightness and position are very important to insure safety and correct functioning every time you use the collar. All electronic collars need to be very snug to work properly. They must be just tight enough to allow the electrodes and the sensor to make good skin contact.
Turning the Unit ON: Touch either magnet to the White Dot on the side of the 1125DT collar box for approximately one half second until the number 0 flashes briefly on the LED Display. The number 0 will be followed immediately by another number (0-8) which will flash for approximately 1.5 seconds.
BATTERY OPERATION NOTE The battery was partially charged prior to shipment. It is necessary, however, to charge the battery for 15-20 hours before initial use. When the sub LED light on the display changes to a rapid blink (twice a second) the battery is low and requires charging. Follow these steps to charge the battery: 1.
If the tester doesn’t light, wait 3 seconds then repeat the process. MAINTENANCE It is very important to periodically clean your 1125DT No Bark trainer for maximum performance. Regular cleaning will also lengthen the life of your unit.
Therefore never leave the unit on your dog while unsupervised. Your 1125DT No Bark Trainer is a very valuable tool if used correctly. Therefore it is extremely important that you completely understand all functions of the collar and how to properly train with it before placing it on your dog.