Testing; Maintenance - D.T.Systems NO BARK TRAINER Instruction Manual

1. Place the two red wires from the Test Light onto the
electrodes (as shown in the picture above).
2. Turn the unit ON using either magnet.
3. Slide the bottom of the test light (the serrated edge) across the top
of the sensor.
4. If the light comes on, the unit is functioning properly.
• Higher intensity levels will cause the Tester to light up brighter.
• If the tester doesn't light, wait 3 seconds then repeat the process.
• It is very important to periodically clean your 1145DT No Bark
trainer for maximum performance. Regular cleaning will also
lengthen the life of your unit.
• Clean the 1145DT collar box with lukewarm water and a mild
anti-bacterial soap.
• Take care to thoroughly clean the space between the electrodes
and the belt.
• The belt and buckle should be cleaned with water and a mild soap
then allowed to dry completely.
• Always allow the entire unit to completely dry before
using. Never completely submerge the unit.

TESTING

MAINTENANCE

10