Related Manuals for D.T.Systems H2O 1810 PLUS
Summary of Contents for D.T.Systems H2O 1810 PLUS
- Page 1 PLUS Series Electronic Dog Trainer Owner’s Manual • H O 1810 PLUS • H O 1820 PLUS • H O 1830 PLUS • H O 1850 PLUS...
-
Page 3: Table Of Contents
TABLE OF CONTENTS • Table of Contents ........3 • Introduction..........4 • Package Contents ........5 • Model Features........... 6 • Parts & Functions ........7 • Charging the Batteries ........ 12 • Turning ON and OFF ........13 •... -
Page 4: Introduction
INTRODUCTION Congratulations and thank you for purchasing our H PLUS Series Training Collar with “Add-On” capability. It offers the Maxx-Range™ Internal Antenna System, the industry’s only internally woven antenna in the collar. With up to a one mile range, they are perfect for hunting, basic obedience, and professional training. -
Page 5: Package Contents
IMPORTANT NOTE: Please read this owner’s manual in its entirety before operating this unit. Should you have any questions about our collars or their operation please contact our Customer Service department (see back page for address and phone number information). PACKAGE CONTENTS •... -
Page 6: Model Features
MODEL FEATURES O PLUS Series • Digital Technology • Up to one mile range • Expandable to 2- or 3-dog* system with H O Add- On collar units (sold separately) • Lightweight, waterproof collar and transmitter • No-Slip/Soft-Grip transmitter FLOATS on water! •... -
Page 7: Parts & Functions
PARTS & FUNCTIONS *The H O 1810 PLUS will not have the #1 or #2 buttons. Red LED Indicator Light Intensity Dial Momentary ‘Nick’ Stimulation Button #2* Button #1* (Function varies (Function varies according to model) according to model) Continuous Stimulation Collar Selecting Switch... -
Page 8: Collar Receiver
PARTS & FUNCTIONS O 1850 PLUS only. Collar Belt with All other models will not MAXX-Range™ have Beeper Horn or Antenna Beeper Wire. Beeper Horn* Beeper Wire* Contacts LED Indicator Light ON/OFF Button Charging Receptacle Collar Receiver PARTS & FUNCTIONS Intensity Selection Dial The intensity selection dial can be set from level 1 to level 16 to find... - Page 9 PARTS & FUNCTIONS Transmitter Antenna Be sure to check that the antenna is securely fastened to the transmitter before each use. Hand tighten only. Use care when attaching antenna. Over-tightening may cause damage to the antenna or antenna mount. Momentary and Continuous Stimulations Pressing the upper button will make the collar give a Momentary (or ‘Nick’) Stimulation.
- Page 10 PARTS & FUNCTIONS Rise Button O 1830 PLUS only) Pressing the button on the right (#2) of the transmitter will make the collar give a stimulation that gradually increases in intensity level the longer the ‘Rise’ button is pressed. Locate and Run/Point Buttons O 1850 PLUS only) Pressing the ‘Locate’...
- Page 11 PARTS & FUNCTIONS Collar Indicator Light When the Collar Receiver is turned on, the Red LED light will flash steadily once every two seconds to indicate that the unit is active. The Red LED light changes to a rapid flash when the battery is in need of charging.
-
Page 12: Charging The Batteries
CHARGING THE BATTERIES All H O PLUS Series units are equipped with rechargeable Nickel Metal Hydride (NiMH) batteries. NiMH batteries are not memory sensitive and do not require depletion before recharging. The batteries come partially charged from the factory. However, it is recommended that the batteries are given a full charge (about 12 hours) before initial use. -
Page 13: Turning On And Off
CHARGING THE BATTERIES NOTE Rechargeable batteries typically last about 2-5 years on av- erage depending on use and care. Do not overcharge your unit (12 hour maximum charge time). Do not store your unit without a charge for extended periods of time. Do not store your unit in extreme heat/cold or moist/humid conditions. -
Page 14: Testing
TESTING NOTE: Before testing, make sure that both units are fully charged and the power to the Collar Receiver is “ON”. To Test the Electronic Stimulation: A) Place the tester firmly on the contacts of the Collar Receiver. B) Set the intensity (note - an intensity level setting of 4 or less might not be enough to light the tester). - Page 15 TESTING To Test the Rise: O 1830 PLUS only) A) The Rise feature will gradually increase the inten- sity level starting from the level set on your dial. To see a greater range of intensity change, set the intensity dial to a lower level. B) Press and hold the button on the right side of the transmitter (Rise button) and the test light will get brighter as the button is held.
-
Page 16: Programming The Collar
PROGRAMMING THE COLLAR When adding an “Add-On” collar, the collar will need to be programmed to the transmitter. If your current collar unit is not responding to the transmitter, it may also need to be reprogrammed to the transmitter. 1. Select the desired Collar Selecting Switch position on the transmitter. -
Page 17: Properly Fitting The Collar
PROPERLY FITTING THE COLLAR NOTE: Proper collar tightness and position are very important to insure safe and consistent collar use. All electronic collars need to be very snug around the dog’s neck to work properly. They must be just tight enough to allow the “contacts”... -
Page 18: Setting Intensity Levels
SETTING THE INTENSITY LEVEL It is very important to set the correct intensity level on your H O PLUS Training System before beginning your training sessions to provide the proper level of stimulation without over-stimulating your dog. To do this, place the Intensity Selection dial so that the system is set on Level 1. - Page 19 SETTING THE INTENSITY LEVEL Jump stimulation is a great feature when regularly us- ing two different stimulation levels in training. It is also a great safety tool for emergency situations when your dog is excited and cannot feel or ignores the normal intensity level.
-
Page 20: Maintenance
MAINTENANCE It is very important to periodically clean your H PLUS Series systems for maximum performance. Regular cleaning will also lengthen the life of your unit. • Clean the H O PLUS Series collar box with lukewarm water and a mild anti-bacterial soap. •... -
Page 21: Important Safety Notes
IMPORTANT SAFETY NOTES • Before training, your dog should be examined by a veterinarian to assure that your dog is in good health. • Never leave your dog unattended with the unit on. Since no electronic device is perfect, there is a very slight possibility that your dog may receive an unintentional electric stimulation. -
Page 22: Warranty
WARRANTY D.T. Systems Premium Lifetime Warranty is the best warranty offered in the industry. This warranty is free to participating U.S. customers (a completed warranty registration card must be returned within 30 days of original purchase). This changes our normal one year parts and labor warranty to a limited lifetime warranty against manufacturing defects on parts and a one year warranty on labor. -
Page 23: Fcc Compliance
WARRANTY How the Limited Lifetime Warranty works: • To qualify for the Warranty you must fill out the warranty registration card which came with your system and mail it (with your original sales receipt) to D.T. Systems within 30 days of purchase. •... -
Page 24: Contact Information
2872 Walnut Hill Lane Dallas, Texas 75229 Tel: (214) 350-9446, (888) 588-8364 Fax: (214) 350-7847 Website: www.dtsystems.com E-mail: customerservice@dtsystems.com O PLUS 2009.09.16 Printed in Korea...