Congratulations and Thank you for purchasing one of dog training systems. The SPT series represents the absolute latest techno- logical advancement in the Electronic Dog Training World. They offer compact lightweight collar receivers which include completely internal antenna systems. The convenient, one-touch Digital Transmitters are lightweight and feature a new patent pending LCD display which allow for extreme ease of use.
IMPORTANT NOTE Please read this owner’s manual entirely before attempting to operate this unit. Should you have any questions about our collars or their operation please contact our Customer Service department. (See last page for contact information) FEATURES Every Electronic Dog Training System Features: •...
INDIVIDUAL MODEL FEATURES SPT 7000 and SPT 7002 • The SPT 7000 features the options of Momentary (Nick) Stimulation, and Constant Stimulation, and adds the feature of No-Bark training. • The SPT 7002 has the same features as the SPT 7000 and comes with two Collar Receiver units which are operated from the same transmitter.
Page 6
INDIVIDUAL MODEL FEATURES CONT. SPT 7200 and SPT 7202 • The SPT 7200 features the options of Momentary (Nick) Stimulation, Constant Stimulation and Positive Vibration. The Constant Stimulation and Vibration features can be operated separately or simultaneously. • The SPT 7202 has the same features as the SPT 7200 and comes with two Collar Receiver units which are operated from the same transmitter.
ADJUSTING & POSITIONING YOUR COLLAR FOR PROPER FIT Proper collar tightness and position are very important to insure safety and correct functioning every time you use the collar. • All electronic collars need to be very snug to work properly. They must be just tight enough to allow the “prongs”...
TURNING YOUR COLLAR ON & OFF Turning the Unit On: Press and hold the Power/Mode button on the Collar Receiver. The Red LED Indicator will light solidly for two seconds. Continue holding the Button until the Red light goes off. The unit is now On.
INTENSITY LEVEL CONT. The first and most important step in training your dog with your SPT Training System is the determination of the cor- rect Intensity Level to provide the proper training stimula- tion without over shocking your dog. To do this place the Collar on the dog’s neck and turn it on.
Page 12
NO-BARK TRAINING MODE CONT. Our No-Bark Trainers have a three second safety delay. Once a corrective stimulation is administered the unit will not shock again for three seconds, no matter how much the dog is barking. This prevents constant shocking which could be harmful to the dog’s health.
REMOTE TRAINING MODE Depending upon which model Trainer you have there will be either Two or Four Stimulation Buttons. The “Nick” Button applies a very quick shock. The Constant Stimulation Button applies a constant shock up to 8 seconds. Causes the Collar Receiver to Vibrate. Applies the Constant Stimulation and the Vibration simultaneously up to 8 seconds.
BATTERIES • All training collars are equipped with rechargeable Nickel Metal Hydride (NiMH) batteries which are not memory sensitive and do not require depletion before recharging. • The batteries come partially charged from the factory, but will require a full charge before the first use. (12 hours). •...
TESTING There are three methods you can use to test your depending upon your model’s features. First, you should make sure that both the transmitter and receiver are fully charged. Then turn on the power to the collar receiver. Next, follow one of these three steps: To Test the Electronic Stimulation: A) Place the tester firmly on...
TESTING CONT. To Test the No-Bark Feature (on equipped models): A) Place the two red wires from the Test Light onto the electrodes (as shown). B) Quickly and steadily slide the bottom of the test light (the serrated edge) across the top of the sensor.
IMPORTANT SAFETY NOTES • Before beginning training your dog should be examined by a veterinarian to assure that there are no physical reasons for your dog’s excessive barking and to assure that your dog in good health. • Your is a very valuable tool if used correctly.
WARRANTY What is covered: D.T. Systems Warranty is one of the best offered in the industry, and is free to participating U.S. customers. D.T. Systems covers all of our systems to be free from manufacturing defects. This warranty goes into effect on the date of original purchase and expires one year from that date.
FCC COMPLIANCE Your has been manufactured under complete compliance with the Federal Communication Commission (FCC). The complex internal structure of each product has been designed to operate within specific regulations of FCC specifications. Any unauthorized modifications to your product is a violation of these specifications.