Your Base Station; Register Handset - Yealink W73P User Manual

Your base station

Press the paging key to make your handset ring when you
can't find it.
• Toggle through the registration mode.
• Reset the base station to its factory settings.
Check the base station's mode with the registration LED.
• Fast green flashes = the station's in paging mode.
• Slow green flashes = the station's in registration mode.
• Steady green light = a handset is registered to the base
station.
• No light = there's no registered handsets.
databoxsolutions.com.au
Check your base station's connected to
the internet with the
network status LED.
• Slow green flashes = the station's
offline.
• Steady green light = the station's
connected to the internet.
Check power with the power indicator
LED.
• Slow green flashes = the station's
upgrading its firmware.
• Steady green light = the station
has power.
• No light = the station doesn't have
power.

Register handset

The handset that came with your Yealink W73H DECT IP phone is already
registered. But you'll need to register any separate handset to a base station - you'll
know you need to do this if the screen says 'Press base paging 2s then press OK'.
To register a handset:
• Press and hold the button on the base station until the
• Press the Reg soft key on the handset.
If this doesn't work, try registering from the handset:
• Press
OK
• Select Register Handset
• Choose your base station from a list of nearby devices then press
• Once the handset's found it, press
• Enter the base station PIN (default: 0000).
Press the Done soft key to finish registering the handset.
•
The handset screen will briefly show 'Handset Subscribed' and 'Base NOXXXX'
(The 'X's represent the last four characters of the connected base station's unique
Media Access Control, or MAC, address, so you know which of your base stations the
handset is connected to. )
Once registered, its name and number will show on the home screen.
flashes
OK
again.
OK
1300 603 404 2