Table of Contents
Advertisement
Part 1 – Introduction
Overview
Product color and design may vary depending on the model.
Body
6
1
2 3
4
Lens
1
Factory Reset Switch (White)
2
IR LED
3
Body
4
Cable
5
Sun Shield Screw Hole
6
• Lens
Fixed lens is installed.
• Factory Reset Switch (White)
Restores the camera's default factory settings. For
more information, refer to the Factory Reset.
• IR LED
The sensor (black) in the upper middle detects low
illumination and the IR LEDs are lit at night or under
low lighting conditions.
• Body
The cables are connected through the body.
8
5
• Cable
Refer to the Cable.
• Sun Shield Screw Hole
Allows you to screw the sun shield to the camera.
Camera surveillance may be prohibited by laws that
vary by region. Check the laws in your area before
using this product for surveillance purposes.
Waterproof Sealing
The waterproof sealing (black rubber) is attached inside of the
camera.
Make sure that the waterproof sealing is held
into the camera body tightly when reconnecting
the lid after removing it to perform a factory
reset. If the waterproof sealing is not held into
the camera body properly, the IP66 level is not
guaranteed. For more information, contact your
product retailer.
Advertisement
Table of Contents
