Table of Contents
Advertisement
Part 1 – Introduction
Factory Reset
Only use the factory reset switch to restore the camera
to its factory default settings.
A factory reset will clear all camera settings configured
by the user.
1
Shut off the power supply, separate the lid of the
camera front by turning it counterclockwise. Insert a
straight pin into the switch hole, and press down on
the reset switch.
2
Hold the switch down and reconnect the power.
3
After connecting the power, wait 5 seconds and
then take out hands from the switch.
4
The device will go through the resetting process and
reboot. All camera settings will be restored to their
factory defaults after the reboot.
5
Reconnect the lid of the camera front.
10
It's also possible to do a factory reset by pressing and
releasing the reset switch while the camera is turned
on or using the IDIS Discovery program from a remote
location. A factory reset will reboot the system. For more
information on resetting the camera remotely, refer to
the IDIS Discovery operation manual.
Make sure that the waterproof sealing is fixed properly
to the camera body when reconnecting the lid.
Otherwise, the IP66 level is not guaranteed. For more
information, contact your product retailer.
Advertisement
Table of Contents
