Table of Contents
Advertisement
A) Enter Programming Mode with Master Code
Entry of Master Code
NOTE: Factory has put a master code
for first �me use.
B) System Refreshing – Installer Programming
Refresh Code
Confirm
C) Code Entries – User Programming
1) Recording Master Code and User Codes – User Programming
Loca�ons
User IDs
00 to 99
2) Recording Super User Code – User Programming
Loca�on
Entry of Code
4 to 8 digits
3) Recording the Visitor Codes – User Programming
Loca�on User IDs Opera�onTime Entry of Code Confirm
0 to 9
D) Configura�on of Output Modes – Installer Programming
Loca�on Code of Timing
1 to 999
STANDARD PROGRAMMING SUMMARY CHART
Confirm
Comments
Set system to Programming Mode
Comments
Clear all previously stored data and set keypad back to default values except
Master Code
Entry of Codes
4 to 8 digits
4 to 8 digits
Confirm
00 to 99
4 to 8 digits
Confirm Comments
Output 1, Momentary Mode from 1 to 999 seconds (default=1 second)
Output 1, Start / Stop Mode (toggle)
Output 1, Start / Stop Mode (toggle) with 2-digit Accelerated start code
Output 1, Start / Stop Mode (toggle) with 3-digit Accelerated start code
(Exit-Factory Master Code: 0 0 0 0)
into the keypad before exit-factory, owner may take it
(Default: 8 9 0 1, Mul�-user mode)
Confirm Comments
Owner's Master Code for se�ng system to
programming mode
100 User Codes for opera�ng Output 1(Door Lock)
Comments
Owner's Mul�-task User Code
6
(No Default Codes)
(No Default Codes)
(No Default Codes)
Comments
10 visitor codes for opera�ng Output 1.
Opera�on Time:
00 = One �me use only
01 to 99 = Valid within �me
limit of 1-99 hours
(Default: Momentary, 1-second)
Advertisement
Table of Contents
