Table of Contents
Advertisement
Programming A New Master Code
NOTE:
● Loca�on
is the storage loca�on for the master code.
● The master codes can be 4-8 digits long.
● User codes must have the same length as the master code if the keypad is in auto code entry
mode.
Programming Example :
1. Set keypad to programming mode with master code and
factory-set master code 0 0 0 0 as example here:
2. Program a new Master Code 3 2 8 9 for the keypad:
3. Exit programming mode by pressing the
NOTE:
● The keypad has a new master code 3 2 8 9 now.
● The owner can use the new master code to set the keypad into programming mode in the future
and does not require to use DAP jumper every �me.
System Refresh (Complete Data Refresh)
Some�mes it may require to completely erase all the current data in memory (except the master
code) and set the keypad back to its default values as like a new unit. This may be necessary while
the stored data can not be traced or for a new owner who bought a house with a keypad installed.
The procedures are as follows:
1. Set keypad to programming mode with master code and
master code 3 2 8 9 as example here:
2. Enter the system refresh code and confirm with
except the Master Code:
3. Enter the required new data for the keypad. See "Programming Summary Chart" for the available data.
4. Exit programming mode by pressing the
all the required data are entered.
NOTE:
● The keypad is in Manual Code Entry Mode (default) a�er refreshing.
Loca�on
New Master Code
Confirm
key.
key. Taking the previous programmed
key to clear all the current stored data
to make keypad back to normal opera�on mode a�er
10
(Loca�on 0 )
key or DAP jumper. Taking the
(Refresh Code 8901)
Advertisement
Table of Contents
