Table of Contents
Advertisement
Programming The User Codes
One group of user codes can be programmed to operate output 1 for door open. The following are
the programming procedures.
Output 1
NOTE:
● Loca�on 1 is the storage place for the User Codes for Output 1.
● 100 unique User IDs 00-99 for 100 User Codes.
● The user codes can be 4-8 digits long in manual code entry mode; but must have the same length
as the master code if the keypad is in auto code entry mode.
● See "Programming Summary Chart" Sec�on C – 1 for more informa�on
● See informa�on on Loca�on 82 concerning digit length in Auto and Manual code entry modes.
Programming Example :
1. Set keypad to programming mode with master code and
master code 3 2 8 9 as example here:
2. Program an User Code 8 3 2 1 for output 1 ---------- One of the 100 user codes (user ID: 00-99,
taking ID = 01 as example):
3. Exit programming mode by pressing the
Operation (Manual Code Entry Mode)
Press
NOTE:
In Auto Code Entry Mode only the User Codes that have the same digit length as the master code are
valid and press the
Loca�ons
User ID
00 - 99
---------- Output 1 ac�vates (The door is open)
key is not required.
Entry of Code
4 -8 Digits
key. Taking the previous programmed
11
(Loca�on 1)
Confirm
Advertisement
Table of Contents
