Table of Contents
Advertisement
IMPORTANT! PRIOR
TO CONNECTING ANY
INTERFACE CABLE
AND POWER CABLE TO
PRINTER, MAKE SURE
PRINTER IS OFF.
NOTE: EZ-LP IS
CONFIGURED TO USE
STANDARD STRAIGHT-
THROUGH SERIAL
CABLE WHEN USING
THE COM/SER PORT
TO CONNECT TO A DTE
DEVICE SUCH AS A
COMPUTER.
Chapter 2: Printer Installation
Setting up the EZ-LP Printer
Connecting the Interface and Power Cables
1.
Make sure power switch is OFF
3.
Connect the AC adapter to the power
connector on the printer
5.
Connect the interface cable to the rear of the printer. For Serial or Parallel cables, securely
fasten the interface connector screws or clips.
USB
Power OFF
USB-B
(Device)
ETHERNET
Power OFF
POWER OFF
Ethernet
2.
Connect power cable to AC adapter
4.
Plug the power cable into an AC
outlet
I O I O
COM/SER
Power OFF
Serial
(DB9)
PARALLEL
Parallel
(Centronics)
Power OFF
Ferrite Bead
(Install on Parallel Cable as Shown)
7
Advertisement
Table of Contents
