Table of Contents
Advertisement
IMPORTANT! IF BAUD
RATE BETWEEN HOST
SYSTEM AND EZ-LP
ARE NOT EqUAL,
PRINTER WILL NOT
PRINT. EZ-LP DEFAULT
BAUD RATE IS 9600
AND DEFAULT SERIAL
PORT SETTINGS ARE
9600 BAUD, 8 BITS, NO
PARITY, 1 STOP BIT.
Chapter 3: Installing the EZ-LP
Installing Printer via Serial, Parallel, or USB as a Replacement
for Legacy Printer
1. Print configuration label or record your current printer's settings, including the
driver port setting.
2. Power off your current desktop label printer and disconnect interface cable.
3. Connect power supply to EZ-LP printer and plug into wall. Do NOT turn on the
EZ-LP at this time.
4. Connect preferred interface cable to EZ-LP and connect to PC.
5. Turn on the EZ-LP printer.
6. If using a USB connection, a New Hardware Wizard may appear on screen. Click
Cancel and continue with step 8 below. If using Serial or Parallel connection,
continue with the next step.
7. Print from your application, you are finished. If you wish to install EZ-LP and
assign it to another driver, continue to the next step.
8. In Microsoft Windows, click the Start menu, choose Printers and Faxes, and
Add printer.
9. The Add Printer Wizard will appear. Click Next.
10. Select Local printer attached to this computer and click Next.
11
Advertisement
Table of Contents
