Related Manuals for Sony PL-ES3
Summary of Contents for Sony PL-ES3
- Page 1 DATA PROJECTOR VPL-ES3 VPL-EX3 VPL-ES4 VPL-EX4 VPL-EX5 VPL-EX50 VPL-EX5U VPL-EW5 PROTOCOL MANUAL 1st Edition (Revised 3)
- Page 2 ! WARNING This manual is intended for qualified service personnel only. To reduce the risk of electric shock, fire or injury, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. Refer all servicing to qualified service personnel.
-
Page 3: Table Of Contents
Table of Contents 1. Introduction 2. RS-232C 2-1. Communication Specifications .......... 1 2-2. Command Block Format ............ 2 2-3. Block Format ..............3 2-4. Connection ................. 4 2-5. Communication Procedure ..........4 2-5-1. Outline of Communication ........4 2-6. Communication Rules ............5 2-7. -
Page 5: Rs-232C
1. Introduction This protocol manual describes the basic configuration and basic operations of various commands used for projector. Projector can be controlled using the commands provided in “Appendix”. Using an external CONTROLLER , etc., inputs can be switched and the power can also be turned on and off. In the follow- ing paragraphs, “CONTROLLER”... -
Page 6: Command Block Format
2-2. Command Block Format The code from B0 to B7 as described below are transmitted. Transmission from Reception in Reception in the Master side the Master side the Master side (With Data) START CODE : 0 x A9 ITEM NUMBER ACK / NAK ITEM NUMBER REPLY... -
Page 7: Block Format
2-3. Block Format Transmission from the Master side Data transmission to the Projector Start of Command START CODE Set the Data Category Value desired. ITEM NUMBER Refer to the Appendix Table 1 for details. SET: 0 x 00 (Set data) SET / GET GET: 0 x 01 (Get data) SET: Data to be set (Refer to the Appendix Table 2) -
Page 8: Connection
2-4. Connection <RS-232C Connection> Communication is enabled by the use of a D-Sub 9 Pin cross (reverse) cable. The pin assignment of D-Sub 9 Pin and D-Sub 25 Pin is as follows. D-Sub 9 Pin D-Sub 25 Pin Name Shell = FG Grounding for safety protection or cable shield Transmission data Reception data... -
Page 9: Communication Rules
2-6. Communication Rules . When sending a command from CONTROLLER, the return Data from PROJECTOR should be received first before sending the next command. Even if the next command is sent before receiving the return Data, since PROJECTOR will not be able to receive that command, it does not return a response to CONTROLLER. -
Page 10: Appendix
Appendix VPL-ES3/EX3 <Table 1> <Table 2> Item Number Data Remarks Item Upper byte Lower byte Data Upper byte Lower byte Input Video Set/Get S-Video Input-A Input-B Picture Mode Dynamic Standard Game Living Cinema Presentation Contrast Setting value (0 - 100) 00h-64h Brightness Setting value (0 - 100) - Page 11 <Table 1> <Table 2> Item Number Data Remarks Item Upper byte Lower byte Data Upper byte Lower byte Status Error No Error Get only Lamp Error Fan Error Cover Error Temp Error Status Power Stanby Startup Lamp Power On Cooling1 Cooling2 Saving Cooling1 Saving Cooling2...
- Page 12 Appendix VPL-ES4/EX4 <Table 1> <Table 2> Item Number Data Remarks Item name Upper byte Lower byte Item name Upper byte Lower byte Video Set/Get S-Video Input Input-A Input-B Dynamic Standard Natural Picture Mode Game Living Cinema Presentation Contrast Set Value 00h - 64h (0 - 100) Brightness Set Value...
- Page 13 <Table 1> <Table 2> Item Number Data Remarks Item name Item name Upper byte Lower byte Upper byte Lower byte No Error Lamp Error Status Error Fan Error Cover Error Temp Error Stanby Start Up Lamp Power On Cooling1 Status Power Cooling2 Saving Cooling1 Saving Cooling2...
- Page 14 Appendix VPL-EX5/EX50/EX5U/EW5 <Table 1> <Table 2> Item Number Data Remarks Item name Upper byte Lower byte Item name Upper byte Lower byte Video Set/Get S-Video Input Input-A Input-B Dynamic Standard Game Picture Mode Living Cinema Presentation Contrast Set Value 00h - 64h (0 - 100) Brightness Set Value 00h - 64h (0 - 100)
- Page 15 <Table 1> <Table 2> Item Number Data Remarks Item name Item name Upper byte Lower byte Upper byte Lower byte No Error Lamp Error Status Error Fan Error Cover Error Temp Error Stanby Start Up Lamp Power On Cooling1 Status Power Cooling2 Saving Cooling1 Saving Cooling2...
- Page 16 VPL-ES3/EX3/ES4/EX4/EX5/EX50/EX5U/EW5...
- Page 17 VPL-ES3/EX3/ES4/EX4/EX5/EX50/EX5U/EW5...
- Page 19 The material contained in this manual consists of information that is the property of Sony Corporation. Sony Corporation expressly prohibits the duplication of any portion of this manual or the use thereof for any purpose other than the operation or maintenance of the equipment described in this manual without the express written permission of Sony Corporation.
- Page 20 VPL-ES3 (SY) VPL-EX3 (SY) VPL-ES4 (SY) VPL-EX4 (SY) VPL-EX5 (SY) VPL-EX5 (CH) VPL-EX50 (SY) VPL-EX50 (CH) VPL-EX5U (SYY) VPL-EW5 (SY) English Sony EMCS Corporation VPL-EW5 (CH) E 2008DR16-1 Ichinomiya Tec 9-872-786-04 ©2006...