Wiring And Installation; Wiring - HIKVISION DS-2AE7232TI-A Quick Start Manual

The speed dome is self-adaptive to private protocol when the No.8 and 9 switches are both
OFF.
 TVI Mode
For convenient settings, refer to the following list to set the TVI mode of the speed dome.
 Terminal Resistor
The No. 1 and No.2 of SW2 switches are used for turning on/off the 120Ω terminal resistor.

1.3 Wiring and Installation

There are several ways to install the speed dome. The wall mounting is taken as an example below.

1.3.1 Wiring

The survey of the actual installation environment and planning the wiring is highly recommended
before the accurate deployment of the wire is implemented in order to provide a safe and steady
power supply and a reasonable wiring route.
 Get familiar with the installation environment before deploying the wire, including the wiring
distance, surrounding, and electromagnetic interference and so on.
 Please choose the cable with nominal voltage higher than the actual voltage, to ensure a
normal running in case of unsteady voltage.
HD-TVI Speed Dome·Quick Start Guide
Table 1-20 Protocol
Switch No.
Protocol
Self-adaptive
Pelco_P
Table 1-21 TVI Mode
Switch No.
TVI Mode
V2.0
V1.0
Table 1-22 Terminal Resistor
Switch No.
Turn on the Resistor
Turn off the Resistor
11
8 9
OFF OFF
ON OFF
10
OFF
ON
1 2
ON ON
OFF OFF