Installing The Bracket - HIKVISION DS-2AE7232TI-A Quick Start Manual

 To protect the power cable and the signal transmitting cable from human tampering, you
should pay attention to the protection and reinforcement of the cables.
 When deploying the wire, please do not tighten the wire or make the wire loose.
The wiring of the speed dome should be performed by professionals.

1.3.2 Installing the Bracket

Before you start:
Wall mounting is applicable to the indoor/outdoor solid wall construction. The followings are the
mandatory precondition for wall mounting:
 The wall must be thick enough to install the expansion screws.
 Please make sure that the wall is strong enough to withstand more than 8 times the weight of
the dome and the mount.
Steps:
1. Check whether the type of the bracket and the number of accessories are right, as shown in
the figure below.
2. Drill 4 screw holes in the wall according to the holes of the mount, and then insert M8
expansion screws (not supplied) into the mounting holes.
3. Attach the wall mount to the wall by aligning the 4 screw holes of the mount with expansion
screws on the wall.
4. Secure the wall mount with 4 hex nuts and washers.
HD-TVI Speed Dome·Quick Start Guide
Figure 1-12 Wall Mount Bracket, Nuts and Flat Washers
Figure 1-13 Drill Mounting Holes
12