Table of Contents
Advertisement
6.2.2 Cutting Method
The TM-U300 can select the partial cut method from Driver or ESC/POS command control.
There are two partial cut methods, one is three points left method, the other is one point left
uncut.
The TM-U220 allows you to select Partial cut (one point is left uncut at the right position) or Full
cut (optional factory setting). These cannot be selected using the driver or with ESC/POS
commands.
6.2.3 Dimensions
Some dimensions of the TM-U220 are smaller than those of the TM-U300 except Type D.
Therefore, the TM-U220 can be installed in the same space as a TM-U300.
Dimensions
Type A:
(W x D x H)
Type B:
Type C:
Type D:
See "External Dimensions and Mass" (page 1-15) for details.
6.2.4 Receive buffer size
This topic is for serial model.
The receive buffer size of the TM-U220 can be changed as shown in the following table.
Product
Receive buffer capacity
TM-U300
40 bytes
(DIP SW1-2 is On)
(ANK: DIP SW1-2 is Off)
1K bytes
(Multilingual: DIP SW1-2 is Off)
512 bytes
TM-U220
40 bytes
(DIP SW1-2 is On)
4K bytes
(DIP SW1-2 is Off)
(default)
Rev. H
TM-U300
170 x 288 x 183
170 x 253 x 148
158 x 295 x 145
158 x 235 x 125
Condition of
buffer full
Buffer space is
10 bytes
Buffer space is
16 bytes
Buffer space is
128 bytes
Buffer space is
128 bytes
Notices for Replacement of the TM-U210/TM-U300 6-11
TM-U220 Technical Reference Guide
TM-U220
160 x 286 x 158
160 x 248 x 139
--
160 x 248 x 139
Condition of
Byte number from buffer full to
release full
release full state
state
Buffer space is
10 bytes
20 bytes
Buffer space is
10 bytes
26 bytes
(Regardless of MemSW8-7)
Buffer space is
128 bytes
256 bytes
(MemSW8-7:OFF) (default)
Buffer space is
10 bytes
138 bytes
(MemSW8-7: ON)
Advertisement
Table of Contents
