Epson C31C514452 Technical Reference Manual page 47

Note:
When you use OPOS (OCX driver from EPSON) or the Advanced Printer Driver, you need to install the
driver. When you use ESC/POS commands, you don't have to install drivers. For information on these
drivers, see "Control Method" (page 2-1) and "Install a Printer Driver in the Host PC / POS
Terminal" (page 3-31).
This printer can be installed on a wall. See "How to Install the Printer on a Wall with the WH-10"
in Appendix B for details.
The following sections describe the setup. The flow of preparing to use printer is listed below.
1. Printer setup
2. Adjust various setting ( If you need to)
When you use this printer with a serial interface, you have to adjust the communication
settings. See "Adjusting the DIP Switches" (page 3-15) and "Memory Switches" (page 3-
17) for how to set them.
3. Connect the Pritner to the Host PC/POS Terminal (and Cash Drawer)
4. Driver set up (If you use driver)
5. Complete the setup
Rev. H
Install Ribbon Cassette
("Installing or Replacing the Ribbon Cassette" (page 3-6))
Install Paper Roll ("Installing the Roll Paper" (page 3-7))
 Connect the Pritner to the Power Supply
("Connecting the Power Supply Unit" (page 3-13))
DIP switches ("Adjusting the DIP Switches" (page 3-15))
The DIP switches set serial communication conditions, busy condition,
print column, receive buffer capacity, etc...
Memory switches ("Memory Switches" (page 3-17))
The Memory switches set serial communication conditions,
roll paper width, cover open status handling, etc...
 Paper width ("Adjusting Roll paper width" (page 3-25))
The paper width is set by the spacer & Memory switch setting.
 Roll Paper Near End Detector (For model equipped with the detector)
("Adjusting Position of Roll Paper Near End Detector" (page 3-26))
("Connecting the Printer to the Host PC / POS Terminal" (page 3-27))
("Install a Printer Driver in the Host PC / POS Terminal" (page 3-31))
TM-U220 Technical Reference Guide
Setup 3-5