Table of Contents
Advertisement
Regeneration frequency setup (models with softener)
(Default value: H03; modify the parameter to suit the mains water hardness.
At first use, the salt tank has to be filled. It is subsequently sufficient simply to fill up with
regenerating salt when necessary.
Important:
During normal operation, the dishwasher will perform a
number of washing cycles while regeneration is in
progress. During this time (5-6 cycles) the intake water
will not be treated, but this will not affect the washing
quality.
With values over 60°f an external water treatment device must be used and the regeneration frequency
must be set on H00.
Extra rinse
"Clean water" cycle
Ppm-
mg/l
150
200
300
400
500
600
Rinsing is 10" longer than the standard in each washing
On: enabled – OFF: disabled.
With this option clean water is used for every washing. At
each cycle, the washing water is completely drained and it is
replaced with clean water from rinsing.
On: enabled – OFF: disabled.
N.B.: prolonged use of this option leads to higher detergent
and rinse aid consumption.
21
Hardness
Hardness
(°dH
(°dF
German
French
degrees)
degrees)
Regeneration off
8,5
15
11
20
17
30
22,5
40
28
50
33,5
60
cycle.
Setting level
H00
H01
H02
H03
H04
H05
H06
Advertisement
Table of Contents
