Bkdm-3010 - Sony DME-7000 Maintenance Manual

1-16. Installation of Software

1-16-3. BKDM-3010

Software Installation
Install the operation software for the control panel in
accordance with the following procedures.
[Procedures]
1. Insert the floppy disk labeled "SYSTEM DISK 1" of
BZDM-3020 or BZDM-7020 in the floppy disk drive
of BKDM-3010.
2. Reset the control panel. (Refer to the section 1-15.)
3. The following display appears on the monitor. Then
press "F2" (store flash).
boot store directory directory
floppy flash floppy flash
n
The process takes approximately ten minutes, during
which no other operations are possible.
4. When the installation completes normally, a message
"store flash ROM complete" displays on the monitor.
5. Press "F5" (boot flash) with the floppy disk inserted.
Then the program is loaded from the flash memory
and BKDM-3010 is started.
n
For details, refer to the optional User's Guide BZDM-3020
or BZDM-7020.
1-40 (E)
boot
flash
Starting BKDM-3010 by flash memory
Load a program from the flash memory and start BKDM-
3010 in accordance with the following procedures.
[Procedures]
1. Eject a floppy disk from the floppy disk drive.
2. Reset the control panel. (Refer to the section 1-15.)
3. A program is loaded from the flash memory and
BKDM-3010 is started.
Starting BKDM-3010 by floppy disk
Start BKDM-3010 by loading a program from the floppy
disk without loading a program from the flash memory in
accordance with the following procedures.
[Procedures]
1. Insert the floppy disk labeled "SYSTEM DISK 1" of
BZDM-3020 or BZDM-7020 in the floppy disk drive
of BKDM-3010.
2. Reset the control panel. (Refer to the section 1-15.)
3. The following display appears on the monitor. Then
press "F1" (boot floppy).
boot store directory directory
floppy flash floppy flash
4. A program is loaded from the floppy disk and BKDM-
3010 is started.
boot
flash