Sony PXW-Z190T Operating Instructions Manual page 66

2
Set Network Client Mode >Setting in
the Network menu to On.
Network client mode is enabled, and the
camcorder connects to the Network RX
Station CCM or XDCAM air.
For details about CCM or XDCAM air
operation, refer to the instruction manual for
the Network RX Station or the Help for
XDCAM air.
3
Send an intercom call start signal from
a CCM or XDCAM air to the connected
camcorder.
When the start signal is received from the
CCM or XDCAM air, the intercom
connection icon appears on the monitor
screen (page 15).
4
Send an intercom call end signal from a
CCM or XDCAM air to the connected
camcorder.
To terminate the call, send the end signal
from a CCM or XDCAM air to the
camcorder.
Adjusting the intercom level
When the headset volume button is operated, the
intercom level adjustment bar appears on the
monitor screen.
You can also display the intercom level
adjustment bar on the monitor screen by
assigning Intercom Level to an assignable button
and then pressing that button.
Adjust the intercom level while the intercom level
adjustment bar is displayed.
Press the headset volume up button, turn the SEL/
SET dial up, or press V or b on the V/v/B/b
button to increase the volume.
Press the headset volume down button, turn the
SEL/SET dial down, or press v or B on the V/v/
B/b button to decrease the volume.
23
66
Notes
• The intercom level adjustment that is performed, from
among the following adjustments, when the headset
volume buttons are pressed depends on the headset
function.
 Adjust the intercom level of the headset only
 Adjust both the intercom level of the headset and
the intercom level of the camcorder
 Adjust the intercom level of the camcorder only if
the headset does not support the intercom level
adjustment function
• The following types of trigger operation occur,
depending on the headset function.
 Intercom level value changes by two or more levels
when the headset volume buttons are pressed once
 Intercom level value does not change unless the
headset volume buttons are pressed two or more
times
 Actual volume level does not change unless the
intercom level is changed by two or more levels
 Intercom level adjustment bar does not appear on
the monitor screen even when a volume button is
pressed
• When the intercom level is adjusted on the headset
only, the intercom level adjustment bar does not appear
on the monitor screen.
• The audio quality may deteriorate depending on the
communication status and processing load.