Image Stabilization; Time Data - Sony PXW-Z190T Operating Instructions Manual

Adjusting the audio recording level
For CH1, CH2
Adjusting automatically (AGC):
Set the AUDIO LEVEL (CH1/CH2) dials
(E/F) to the AUTO position.
You can set whether the levels on CH1 and CH2
are automatically adjusted separately (Mono) or
together (Stereo) using Audio Input (page 99)
>CH1&2 AGC Mode in the Audio menu.
Adjusting manually:
During shooting or standby, turn the
AUDIO LEVEL (CH1/CH2) dials (E/F)
of the corresponding channels in the range
0 to 10 to adjust the microphone audio
recording level.
For CH3, CH4
Adjusting automatically (AGC):
Set Audio Input (page 99) >CH3 Level
Control/CH4 Level Control in the Audio
menu to Auto.
You can set whether the levels on CH3 and CH4
are automatically adjusted separately (Mono) or
together (Stereo) using Audio Input (page 99)
>CH3&4 AGC Mode in the Audio menu.
Adjusting manually:
1
Set Audio Input (page 99) >CH3 Level
Control/CH4 Level Control in the
Audio menu to Manual.
2
Set the audio recording level using CH3
Input Level/CH4 Input Level.
To reduce wind noise, set Audio Input >CH Wind
Filter in the Audio menu to On (page 99).
Notes
• When the internal microphone is selected for both CH1
and CH2, the recording audio level of CH1 and CH2
are linked and is adjusted using the AUDIO LEVEL
(CH1) dial.
• When the internal microphone is selected for both CH3
and CH4, the recording audio level of CH3 and CH4
are linked and is adjusted using the AUDIO LEVEL
(CH3) dial.
Audio recording in special recording
modes
Audio is not recorded in Interval Rec mode or
Slow & Quick Motion mode.

Image stabilization

Enabling the image stabilization (SteadyShot)
function suppresses image shaking caused by
camera movement when recording.
Set SteadyShot (page 93) >Setting in the
Camera menu to Active or Standard.
Standard: Reduces shaking of the image due to
camera movement.
Active: Reduces shaking of the image due to
rapid camera movement, such as when
walking, using stronger correction than the
Standard setting.
Off: Turns the image stabilization mode off.
Assign the SteadyShot, SteadyShot Active, or
SteadyShot Standard function to an assignable
button (page 40), and switch the image
stabilization mode between Standard, Active, and
Off by pressing the button. For the switching
order, see Assignable Button (page 122) in the
System menu.
The setting is displayed on the LCD/viewfinder
screen.
The image stabilization mode can also be
switched between Standard, Active, and Off
using the direct menu (page 38).
Notes
• The Active setting is not available in the following
cases.
 When Video Format is 3840×2160
 During Slow & Quick Motion recording
• When shooting using a tripod for stability, set
SteadyShot to Off.

Time data

Setting the timecode
Set the timecode to record using Timecode
(page 105) in the TC/UB menu.
37