Table of Contents
Advertisement
The scanner displays 'Searching for Satellite' in GPS Display Mode until it receives
the signal from the satellite if you have your connections and baud rate set correctly.
The first time the scanner starts receiving a signal from the GPS, it beeps and briefly
displays 'GPS Connected' and (temporary) locks and unlocks all sites and groups
that are 'enabled for scan', unlocked, and whose quick key is enabled according to
your current location. If you have a lot of data programmed, it might take the scanner
a couple of minutes to complete the process. Once the scanner completes the initial
GPS review, if you move into or out of an area covered by a site/group, the scanner
beeps and displays the name of the site/group and whether it is being locked or
unlocked.
If you cycle power, all sites/groups (enabled for scan) are unlocked until the scanner
reacquires the GPS signal and completes the initial GPS review.
When the scanner does not receive GPS data, the scanner displays "No GPS Input".
See also Set GPS Format in the 'Settings' menu to set relevant options for GPS
display modes.
To Program a Current Location (when connected to a GPS) press Func then press
and hold
E/yes(gps) for 2 seconds.
1.
To Program a Current Location (when connected to a GPS) press Func then
press and hold E/yes(gps) for 2 seconds.
2.
The scanner opens a dialog ('Storing Location') to store your current location
(or 'Location Exists', Accept?).
3.
Scroll to 'POI', 'Dangerous Xing', or 'Dangerous Road' to select the type then
press E/yes.
4.
The default name is P (POI), X (dangerous crossing), R (dangerous road),
then YYMMDD hhmmss that indicates the year, month, date, and time you
stored the location point. 'Road', 'Xing', or 'POI' Stored and the default name
with the position will briefly appear.
5.
Continue at 'Edit Name' below.
To Program a New Location press Menu. Scroll to 'Program Location' and press E/
yes.
1.
To Program a Current Location (when connected to a GPS) press Func then
press and hold E/yes(gps) for 2 seconds.
2.
At 'Select Type' scroll to 'POI', 'Dangerous Xing', or 'Dangerous Road' and
press E/yes.
3.
Scroll to 'New Location' and press E/yes.
4.
The default name is DRD (dangerous road), DXG (dangerous crossing), or
POI (point of interest)-####(?).
5.
Continue at 'Edit Name' below.
66
Advertisement
Table of Contents
