Table of Contents
Advertisement
Set GPS Format
Allows you to set the GPS format to DD,MM,SS or decimal degrees (DD.000000),
time format, time zone, and units.
1.
Scroll to 'Set GPS Format' and press E/yes.
2.
Scroll to 'Pos Format' and press E/yes.
3.
Scroll to 'DMS:DDD MM"SS.ss' or 'DEG:DDD.dddddd' and press E/yes to
save and exit.
4.
Scroll to 'Set Time Format' and press E/yes.
5.
Scroll to '12H' or '24H' and press E/yes to save and exit.
6.
Scroll to 'Set Time Zone' and press E/yes.
7.
Scroll to 'Your Time Zone' and press E/yes to save and exit.
8.
Scroll to 'Set Unit' and press E/yes.
9.
Scroll to 'mile' or 'km' and press E/yes to save and exit.
10.
Press Menu to return.
Set GPS Baud Rate
Allows you to set the baud rate for the serial port. You set the port to match the
speed used to communicate to 4800 bps for communicating with BC-GPSK and
BC-UTGC.
1.
Scroll to 'Set GPS Baud Rate' and press E/yes.
2.
Scroll to Off, 4800, 9600, 19200, 38400, 57600, or 115200 and press E/yes
to save and exit.
Band Defaults
Basically, this setting allows you change the 'Auto' values you can select while
programming frequencies, searches, etc. to whatever you feel 'Auto' should be for
each band (vs. the radio defaults). Since all of the step and modulation settings
default to 'Auto', this allows you to skip those settings when programming.
Note: these setting have no effect on service searches.
1.
Scroll to the band you wish to edit and press E/yes.
2.
At 'Set Modulation' scroll to AM, NFM, FM, WFM, or FMB (Broadcast) and
press E/yes to save and exit.
3.
At 'Set Step' scroll to Auto, 5, 6.25, 7.5, 8.33, 10, 12.5, 15, 20, 25, 50, or 100
kHz and press E/yes to save and exit.
4.
Scroll to any other bands you wish to edit and repeat.
38
Advertisement
Table of Contents
