Connecting The Machine - JUKI HZL-70HW-B Instruction Manual

Connecting the machine

Before connecting the power
supply, make sure that the
voltage and frequency shown on
the rating plate is conforming with
your mains power.
Place the machine on a stable
table.
1. Connect the power cord to the
2. Connect the power line plug to
3. Turn on the power switch.
ON
4. The sewing lamp will light up
5. After switching off, it will take
OFF
Always make sure that the
machine is unplugged from power
source and the main switch is off
("O"). when the machine is not in
use and before inserting or
removing parts.
Polarized plug information
This appliance has a polarized
plug (one blade wider than the
other), to reduce the risk of
electrical shock; this plug will fit in
a polarized outlet only one way. If
the plug does not fit fully in the
outlet, reverse the plug. If it still
does not fit, contact a qualified
electrician to install the proper
outlet. Do not modify the plug in
any way.
Foot Control
With the sewing machine turned
off, insert the foot control plug into
its connector on the sewing
machine.
Turn on the sewing machine, and
then slowly depress the foot
control to start sewing. Release
the foot control to stop the sewing
machine.
13
machine by inserting the 2-
hole plug into the mains plug
socket.
the wall outlet.
Connect the foot controller
plug if you use.
when the switch is turned on.
some time to consume the
residual power in the circuitry.
The light does not turn off
immediately after switching off
the power. This is normal
phenomenon for an energy
efficient appliance.
Attention: