Moog Videolarm 81-IN5289 Manual

© 2009, Videolarm, Inc. All Rights Reserved
81-IN5289 Infrared Illuminators
IR10M
REVISION DATE: March 25, 2004
ILLUMINATOR SPECIFICATIONS
Model Power Distance
IR10m 12 VDC 33 ft (10m)
GENERAL INSTRUCTIONS
1. Select an appropriate location for your IR illuminator.
NOTE: Generally the IR unit will be mounted near the camera.
2. Mount the IR10m using the bolt and washer provided. After
aiming in the proper direction, lock the unit down using a screw
(not provided) in the second slot on the bracket (Figure 1).
3. Connect the unit to a 12 VDC power source (such as the
Videolarm PS12).
NOTE: Both a male and female 2.1 mm connector are included
for your convenience (Figure 2).
SPECIFICATIONS
Input Voltage 12VDC, 450mA (+/- 10%)
Output Voltage 12VDC
Distance 33 ft. (10 meters)
H.V. Angle 70˚
Power Consumption 2.0 watts
Power On DCS Auto Control
LED 28 unit Infrared LED
Wave 840 nM
Rating IP68
Construction Aluminum, with original anodized finish
Operating Temperature -4˚ F to 140˚ F
Weight .39 lbs.
Angle Wavelength
70° 840nm
Figure 1
The male center pin is
2.1mm, the opening in
the female connector
is 2.1mm
Figure 2
- 1 -
Center hole for
mounting
Slot for lock
down screw
NOTE: Center pin is positive.