The following describes the NetBIOS packet filter commands. See the Command Interpreter appendix for
information on the command structure.
Introduction
NetBIOS (Network Basic Input/Output System) are TCP or UDP broadcast packets that enable a computer to
connect to and communicate with a LAN.
For some dial-up services such as PPPoE or PPTP, NetBIOS packets cause unwanted calls.
You can configure NetBIOS filters to do the following:
•
Allow or disallow the sending of NetBIOS packets from the LAN to the WAN.
•
Allow or disallow the sending of NetBIOS packets from the WAN to the LAN.
•
Allow or disallow the sending of NetBIOS packets through VPN connections.
•
Allow or disallow NetBIOS packets to initiate calls.
Display NetBIOS Filter Settings
Syntax:
sys filter netbios disp
This command gives a read-only list of the current NetBIOS filter modes.
Diagram O-1 NetBIOS Display Filter Settings Command Example
Syntax:
sys filter netbios disp
The filter types and their default settings are as follows.
NetBIOS Filter Commands
NetBIOS Filter Commands
=============== NetBIOS Filter Status ===============
LAN to WAN:
WAN to LAN:
IPSec Packets:
Trigger Dial:
ZyWALL 2 and ZyWALL 2WE
Appendix O
Forward
Forward
Forward
Disabled
65