Time And Date Setting; Figure 23-6 Menu 24: System Maintenance; Figure 23-7 Menu 24.10 System Maintenance: Time And Date Setting - ZyXEL Communications ZyXEL ZyWALL 2WE User Manual

23.3 Time and Date Setting

The ZyWALL has a software mechanism to set the time manually or get the current time and date from an
external server when you turn on your ZyWALL. Menu 24.10 allows you to update the time and date
settings of your ZyWALL. The real time is then displayed in the ZyWALL error logs and firewall logs.
Select menu 24 in the main menu to open Menu 24 - System Maintenance, as shown next.
Enter 10 to go to Menu 24.10 - System Maintenance - Time and Date Setting to update the time and date
settings of your ZyWALL as shown in the following screen.

Figure 23-7 Menu 24.10 System Maintenance: Time and Date Setting

System Maintenance & Information
Menu 24 - System Maintenance
1. System Status
2. System Information and Console Port Speed
3. Log and Trace
4. Diagnostic
5. Backup Configuration
6. Restore Configuration
7. Upload Firmware
8. Command Interpreter Mode
9. Call Control
10. Time and Date Setting
11. Remote Management Setup
Enter Menu Selection Number:

Figure 23-6 Menu 24: System Maintenance

Menu 24.10 - System Maintenance - Time and Date Setting
Use Time Server when Bootup= NTP (RFC-1305)
Time Server Address= tick.stdtime.gov.tw
Current Time:
New Time (hh:mm:ss):
Current Date:
New Date (yyyy-mm-dd):
Time Zone= GMT+0800
Daylight Saving= No
Start Date (mm-dd):
End Date (mm_dd):
Press ENTER to Confirm or ESC to Cancel:
ZyWALL 2 and ZyWALL 2WE
00 : 00 : 00
11 : 23 : 16
2000 - 01 - 01
2001 - 03 - 01
01 – 01
01 – 01
23-5