Figure 21-2 Menu 24.1: System Maintenance: Status (Zywall 2We); Table 21-1 System Maintenance: Status Menu Fields - ZyXEL Communications ZyXEL ZyWALL 2WE User Manual

ZyWALL 2 and ZyWALL 2WE
monitor your ZyWALL. Specifically, it gives you information on your system firmware version, number of
packets sent and number of packets received.
To get to the System Status:
Step 1. Enter number 24 to go to Menu 24 - System Maintenance.
Step 2. In this menu, enter 1 to open System Maintenance - Status.
Step 3.
There are three commands in Menu 24.1 - System Maintenance - Status. Entering 1 drops the
WAN connection, 9 resets the counters and [ESC] takes you back to the previous screen.
Port Status
WAN Down
LAN Down
WLAN Down
Port Ethernet Address
WAN 00:a0:c5:01:23:46
LAN 00:a0:c5:01:23:45
WLAN 00:00:00:00:00:00
System up Time:

Figure 21-2 Menu 24.1: System Maintenance: Status (ZyWALL 2WE)

The following table describes the fields present in Menu 24.1 - System Maintenance - Status. These fields
are READ-ONLY and meant for diagnostic purposes. The upper right corner of the screen shows the time
and date according to the format you set in menu 24.10.
FIELD
Port
Status
21-2
Menu 24.1 - System Maintenance - Status
TxPkts
0
463
0
IP Address
192.168.1.1
3:06:20
COMMANDS: 1-Drop WAN 9-Reset Counters

Table 21-1 System Maintenance: Status Menu Fields

Identifies a port (WAN, LAN or WLAN) on the ZyWALL.
Shows the port speed and duplex setting if you're using Ethernet Encapsulation
and Down (line is down), idle (line (ppp) idle), dial (starting to trigger a call) and
drop (dropping a call) if you're using PPPoE Encapsulation.
RxPkts Cols Tx B/s
0 0
792 0
0 0
IP Mask
0.0.0.0 0.0.0.0
255.255.255.0
Press Command:
DESCRIPTION
03:06:17
Sat. Jan. 01, 2000
Rx B/s Up Time
0 0 0:00:00
0 0 0:00:00
0 0 0:00:00
DHCP
Client
Server
ESC-Exit
System Information and Diagnosis