Printer And Scanner Sharing; Auto-Connected Printers - EnGenius X-TRA ESR600H Manual

W S
IRELESS ERVICES

7.1.2 Printer and Scanner Sharing

Auto-Connected Printers

The method described in the previous section, refer to "Using the USB Device Server" on page 7-5, demonstrated manually
connecting and disconnecting to a virtual USB device. That procedure applies to USB storage devices but not to printers,
scanners or multifunction printers (MFPs). For these devices, the USB device server supports auto-connect so users don't
need to manually connect and disconnect when using the USB device. The following instructions demonstrate how to use this
feature.
Note:
A device driver must be installed for the USB device with the Control Centre for the auto-connect feature to work.
Refer to "Installation of a USB Device Driver" on page 7-3.
To use the auto-connect feature, do the following:
1. Connect the USB printer to the device server's USB port.
2. Open the Control Centre software to perform a search of available devices.
3. In the Control Center, select the USB device server that has the printer attached.
4. Select the printer.
ESR600H/ESR750H 7-6
P S S
RINTER AND CANNER HARING
U G
SER UIDE