Connecting The Appliance; Automatic Cup Tray Light - Smeg CMS6451X Manual

• Do not install the appliance in rooms where the tempera-
ture may drop to 0°C or lower (the water in the appliance
could freeze and cause damage).
• You should customise the water hardness as soon as pos-
sible following the instructions in the "SETTING WATER
HARDNESS" section.

Connecting the appliance

Danger! Check that the mains power supply voltage
corresponds to the value indicated on the appliance rating pla-
te.
Connect the appliance to an efficiently earthed and correctly
installed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualified pro-
fessional.
To comply with safety directives, an omnipolar switch with a
minimum contact distance of 3 mm must be installed.
Do not use multiple sockets or extensions.
To learn to use the appliance correctly, the first time you use it
follow the detailed instructions in the following sections.
Important! Safety cutout devices must be included
in the mains power supply in compliance with the installation
regulations in the country concerned.

AUTOMATIC CUP TRAY LIGHT

When the appliance is turned on, the lights (A6) automatically
light up the spout and cup tray.
The lights stay on until the appliance is turned off.
While coffee, steam or hot water is being delivered, the cooling
fan comes on.
At the end of the function, the cooling fan remains on to avoid
condensation forming inside the cabinet. After several minutes,
the fan goes off automatically.
N.B.: The appliance also completes this cycle if switched
off by turning the knob (C6) to the right or left.
Important! Do not look at the lights directly or using
an optical instrument.
9