CONTENTS MAKING MILK-BASED HOT DRINKS ........14 Filling and attaching the milk container ......14 INTRODUCTION ..............8 Adjusting the amount of froth ........14 Symbols used in these instructions ........8 Making milk based hot drinks automatically ....14 Letters in brackets ............8 Cleaning the milk container after use ......15 Troubleshooting and repairs ..........8 DELIVERING HOT WATER .............15 Instructions for use ............8...
A5. Infuser INTRODUCTION A6. Lighting to illuminate interior compartment Symbol used in these Instructions A7. On/stand-by button Important warnings are identified by these symbols. Failure to A8. Control panel observe the Instructions for Use could result in electric shock, A9. Tray for objects serious injury, burns, fire or damage to the appliance A10.
D2 Lid with milk frother cappuccinos before it starts to give satisfactory results. D3. Milk container • On first use the water circuit is empty, the machine could D4. Milk intake tube therefore be very noisy: the noise will lessen as the circuit D5.
1. Press (B2) to enter the menu; • first turn the appliance off by pressing the button 2. Press (B10) or (B8) until DRINKS SETTINGS (fig. 9); appears on the display (B); • release the main switch (A23) situated on the side of the appliance (fig. 2).
To enable auto-start, proceed as follows: To disable or enable "Energy Saving", proceed as follows: 1. Press (B2) to enter the menu; 1. Press (B2) to enter the menu; 2. Press (B10) or (B8) until the display (B) shows 2. Press (B10) or (B8) until ENERGY SAVING ap-...
To disable or enable this function, proceed as follows: MAKING COFFEE 1. Press (B2) to enter the menu; (see recipes on page 29) 2. Press (B10) or (B8) until the display (B) shows Selecting the coffee aroma LIGHT; Select the required aroma from the homepage by pressing 3.
Making coffee using coffee beans Making coffee using pre-ground coffee Important! Important! Do not use green, caramelised or candied coffee beans as they • Never add pre-ground coffee when the machine is off in or- could stick to the coffee mill and make it unusable. der to avoid it spreading through the inside of the machine and making it dirty.
preparation. • If "Energy Saving" mode is enabled, there may be a few If the coffee comes out too slowly or seconds delay before the beverage is delivered. does not come out at all, a message will be shown GROUND TOO FINE. ADJUST 1.
• The milk container can be kept in the refrigerator. • In some cases, to carry out the cleaning the appliance re- Please note: general indications when preparing all quires a short time to heat up. milk based drinks • : press to interrupt preparation completely and go DELIVERING HOT WATER back to the homepage.
TO SAVE: Preparation begins and the appliance displays the quantity customising screen in the form of a vertical bar. Please note: The star alongside the bar represents the current quantity If “Energy saving” mode is active, there may be a few seconds set.
Cleaning the drip tray Important! Important! • Do not use solvents, abrasive detergents or alcohol to clean The drip tray (A14) is fitted with a level indicator (red) showing the coffee machine. It is not necessary to use chemical the level of water it contains (fig. 28). products to clean the machine.
Cleaning the pre-ground coffee funnel 5. Wash all the components of the frother thoroughly with hot water and mild washing-up liquid. All components and Check regularly (about once a month ) that the pre-ground the container are dishwasher safe, placing them in the top coffee funnel (A21) is not blocked.
A marked inside the tank (equal to one 100 ml pack); then RINSING PLEASE WAIT is displayed. add water (one litre) up to level B; and put the water tank 18. EMPTY DRIP TRAY (fig. 27): At the end of rinsing, remove, back in.
press as far as it will go. Press Setting water hardness 5. INSERT WATER TANK : Close the tank with the lid (A15), then 1. Press (B2) to enter the menu; replace the tank in the machine. 2. Press (B10) or (B8) until the display (B) displays 6.
5. On the display REMOVE FILTER appears; 6. Press REMOVE FILTER? : press (or to go back to the settings menu, press FILTER REMOVED : the appliance has recognised the change. Press to go back to the homepage. Please note: After two months (see date indicator) or when the appliance has not been used for 3 weeks, you should remove/replace the filter even if the message has not yet been displayed.
DISPLAYED MESSAGES DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY FILL WATER TANK WITH Water in the tank (A12) is not sufficient. Fill the tank with water and/or insert it correctly, FRESH WATER pushing it as far as it will go until it clicks into place. EMPTY GROUND CONTAINER The grounds container (A4) is full.
Page 23
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY ADD PRE-GROUND COFFEE A LONG coffee with pre-ground coffee Place pre-ground coffee in the funnel (A21) (fig. 14) PRE-GROUND MAXIMUM has been requested and press to continue and complete ONE MEASURING CUP delivery. FILL BEAN CONTAINER The coffee beans have run out.
Page 24
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY INSERT WATER OUTLET The hot water spout (C6) is not inserted Insert the water spout as far as it will go. or is inserted incorrectly INSERT MILK CONTAINER The milk container (D) is not inserted Insert the milk container as far as it will go (fig. 19).
Page 25
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY PRESS OK TO START CLEANING The milk container has been inserted To proceed with the CLEAN function, press PROCESS OR TURN MILK with the froth adjustment dial (D1) in the or turn the froth adjustment dial to one of the milk FROTH ADJUSTMENT KNOB CLEAN position .
Page 26
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY GENERAL ALARM: REFER TO The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly, as USER MANUAL described in section “Cleaning”. If the message is still displayed after cleaning, contact an authorised Customer Service centre.
TROUBLESHOOTING Below is a list of some of the possible malfunctions. If the problem cannot be resolved as described, contact Customer Services Technical Assistance. PROBLEM POSSIBLE CAUSE REMEDY The coffee is not hot. The cups were not preheated. Warm the cups by rinsing them with hot water (Please note! the hot water function can be used).
Page 28
PROBLEM POSSIBLE CAUSE REMEDY The milk does not come out of the The lid (D2) of the milk container (D) Clean the milk container lid as described in par. milk spout (D5) is dirty "Cleaning the milk container". The milk contains large bubbles and The milk is not cold enough or is not Use fully skimmed or semi-skimmed milk at squirts out of the milk spout (D5) or...
Page 29
ESPRESSO Origin Italy PROCESS Grinding Coffee powder 6-11gr (according to aroma) Brewing Pre-infusion • Infusion high pressure (9-12 bar) RESULT IN CUP Default Quantity ~ 40ml Cream compact and nut-coloured Taste intense OCCASION OF USE short-term pleasure, every moment of the day COFFEE Origin Germany &...
Page 30
CAPPUCCINO Origin Italy PROCESS Coffee balanced (~ 80ml) Milk balanced (~ 70ml) Milk foam maximum level Delivery order milk first, coffee afterwards RESULT IN CUP Visual separate layers of foam, coffee and milk Milk foam white with milky taste OCCASION OF USE every moment of the day, people who want to taste coffee and milk separately CAPPUCCINO+ Origin...
Page 31
The manufacturer reserves the right to make any changes deemed useful for improvement of its products without prior notice. The illustrations and descriptions contained in this manual are therefore not binding and are merely indicative.
Page 32
SMEG S.p.A. Via Leonardo Da Vinci, 4 42016 San Girolamo di Guastalla (RE) ITALY www.smeg.com...