Technical Specification; Disposing Of The Appliance - Smeg CMS6451X Manual

To turn the appliance off, turn the
The appliance performs the rinse cycle then goes off.
N.B.: If the appliance is not used for an extended period,
place the main switch (A19) on the back of the appliance in the
0 position.

TECHNICAL SPECIFICATION

Voltage: 220-240 V~ 50/60 Hz max. 10A
Absorbed power: 1350W
Pressure: 15 bars
Water tank capacity: 1.7 litres
Size LxHxD: 595 x 455 x 412 mm
Weight: 26 kg
The appliance complies with the following EC direc-
tives:
• Low Voltage Directive 2006/95/EC and subsequent
amendments;
• EMC Directive 2004/108/EC and subsequent amendments
Materials and accessories coming into contact with food con-
form to European regulation (EC) no. 1935/2004.

DISPOSING OF THE APPLIANCE

In compliance with European directive 2002/96/EC, the applian-
ce must not be disposed of with household waste, but taken to
an authorised waste separation and recycling centre.
ELECTRICAL CONNECTION (UK ONLY)
A) If your appliance comes fitted with a plug, it will incorpo-
rate a 13 Amp fuse. If it does not fit your socket, the plug
should be cut off from the mains lead, and an appropriate
plug fitted, as below.
WARNING: Very carefully dispose of the cut off plug after
removing the fuse: do not insert in a 13 Amp socket el-
sewhere in the house as this could cause a shock hazard.
With alternative plugs not incorporating a fuse, the cir-
cuit must be protected by a 15 Amp fuse. If the plug is a
moulded-on type, the fuse cover must be re-fitted when
changing the fuse using a 13 Amp Asta approved fuse to
BS 1362. In the event of losing the fuse cover, the plug
must NOT be used until a replacement fuse cover can be
obtained from your nearest electrical dealer. The colour of
the correct replacement fuse cover is that as marked on the
knob (C6).
base of the plug.
B) If your appliance is not fitted with a plug, please follow the
instructins provided below:
WARNING - THIS APPLIANCE MUST BE EARTHED
IMPORTANT
The wires in the mains lead are coloured in accordance with the
following code:
Green and yellow:
Blue:
Brown:
As the colours of the wires in the mains lead may not corre-
spond with the coloured markings identifying the terminals in
your plug, proceed as follows:
The green and yellow wire must be connected to the terminal
in the plug marked with the letter E or the earth symbol
coloured green or green and yellow.
The blue wire must be connected to the terminal marked with
the letter N or coloured black.
The brown wire must be co
20
Earth
Neutral
Live
or