Bushranger MC-PX-2 Owner's/Operator's Manual page 9

2) Regulating oil discharging rate
The regulating screw has three positions, Minimum, Interme-
diate and Maximum, only.
The regulating screw is set to Intermediate at the time of ship-
ping. It is recommended that the product be used with this
setting for ordinary use.
• Increase the discharging rate when cutting hard
branches or branches with a lot of resin (pitch), or
when the viscosity of the oil is high during winter.
1. Insert a minus screw driver into the regulating screw at the
bottom of the main unit.
2. When applying pressure with the minus screw driver, turn
the screw to the right (clockwise) to reduce the discharg-
ing rate and to the left (counter-clockwise) to increase the
discharging rate.
3. Turn the engine on and turn the saw chain, with the guide
bar facing the ground or tree. Oil will attach to the ground
or tree, if the oil is discharging.
・ Using the pruner with a saw chain too loose may result in the saw chain becoming dislodged
and could cause an accident. Please be sure to check the tension of the saw chain before
starting any work.
Intermediate
Maximum
Be sure to turn the screw while applying
pressure to it with the screwdriver.
WARNING
＿ 8 ＿
Regulating screw
Minimum