General Cleaning And Tightening; Storage; Troubleshooting - Bushranger MC-PX-2 Owner's/Operator's Manual

General Cleaning and Tightening

POTENTIAL HAZARD
・ When engine is running, attached tool and other parts are moving.
WHAT CAN HAPPEN
・ Contact with moving tool or other moving parts could cause serious personal injury or death.
HOW TO AVOID THE HAZARD
・ Always turn off your Multi-Cutter before you clean or perform any maintenance on it.
The BUSHRANGER Multi-Cutter will provide maximum performance for many, many hours if it is main-
tained properly. Good maintenance includes regular checking of all fasteners for correct tightness, and
cleaning the entire machine.

Storage

Please see your Multi-Cutter Power Unit Owner's/Operator's Manual.
1. Perform all regular maintenance procedures and any repairs.
2. Store the Multi-cutter in a dry place away from excessive heat, sparks or open flame.

Troubleshooting

Problem
Engine will not start
Engine will not Idle
Engine lacks power or stalls
when cutting
If further assistance is required, contact your local authorized BUSHRANGER service dealer.
WARNING
Cause
・STOP switch set to off position
・Empty fuel tank
・Primer bulb wasn't pushed enough
・Engine flooded
・Idle speed set incorrectly
・Throttle wire has come loose
・Dirty air filter
＿ 13 ＿
Action
・Move switch to on position
・Fill fuel tank
・ Press primer bulb until fuel flows
through the fuel return line
・Use warm engine starting procedure
・Set Idle speed
・Tighten throttle wire
・Clean or replace air filter