Related Manuals for Bushranger MCH252
Summary of Contents for Bushranger MCH252
- Page 1 Multi-Cutter Power Unit MCH252 Owner’s/ Operator’s Manual Completely read and understand this manual before using this product.
-
Page 2: Table Of Contents
It is essential that any operator of this Multi-cutter reads and understands the contents this manual before using the Multi-cutter. For additional assistance, contact any local authorized BUSHRANGER dealer. Important Notice The benefits to the consumer given by this warranty are in addition to other rights and remedies of the con- sumer under a law in relation to the goods or services to which this warranty relates. -
Page 3: Safety Instructions
5. Inspect the tool attachment and replace any parts that are cracked, chipped or damaged before using the Multi-cutter. 6. Never use a tool attachment or replacement parts that are not approved by BUSHRANGER. 7. Maintain the Multi-cutter according to the recommended maintenance intervals and procedures in the Maintenance section beginning on page 10. -
Page 4: Fuel Safety
9. Keep a firm footing and balance. Do not overreach. 10. Use the right tool for the job. Do not use the Multi-cutter for any job that is not recommended by BUSHRANGER. ＿ 3 ＿... -
Page 5: Safety And Instruction Decals
Safety and Instruction Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any that are damaged or lost. ON ENGINE （Part No. 246020） Product Description 1. Shaft connector 2. -
Page 6: Assembly
Assembly Assembling Engine and Shaft Assembly Engine Attach the clutch drum housing to the engine using the four Screw (4) screws supplied with the unit. Shaft Assembly Clutch Drum Housing Loop Handle Installation Loop Handle 1. Place the loop handle and the bottom clamp on the shaft Screw（4）... -
Page 7: Connecting Stop Switch Wires
Connecting Stop Switch Wires Throttle Cable 1. Plug the stop switch terminal A into the matching Bracket connector from the engine. 2. Fix the stop switch terminal B to the engine body Throttle Cable with the screw (packed with Engine Box). Cable adjuster nut Terminal A... -
Page 8: Attaching And Detaching For The Power Unit And The Shaft Assembly
Attaching and Detaching for the Power Unit and the Shaft Assembly Attaching Shaft Coupler First, loosen the clamping knob before Positioning attaching the shaft assembly to the shaft cou- Lever pler. Note: Do not over loosen the clamping Positioning Hole knob or it may fall out. -
Page 9: Before Operation
Starting Engine Please see HONDA ENGINES Owner’s Manual. Fast-Idle start lock If the engine fails to start after you follow the procedures, START(ON) contact an authorized BUSHRANGER dealer. STOP(OFF) To Stop the Engine Fast-Idle start 1. Release the throttle trigger. -
Page 10: Idle Speed Adjustment
Turn the screw out (counter-clockwise) to decrease the engine idle speed. If idle speed adjustment is necessary, and after adjustment the cutting attachment rotates or the engine stalls, stop using the Multi-cutter immediately! Contact your local authorized BUSHRANGER Dealer for assistance and servicing. ＿ 9 ＿... -
Page 11: Maintenance
・ Always turn off your Multi-Cutter before you clean or perform any maintenance on it. The BUSHRANGER Multi-Cutter will provide maximum performance for many, many hours if it is maintained properly. Good maintenance includes regular checking of all fasteners for correct tightness, and cleaning the entire machine. - Page 12 11 Sodium Street, Narangba Qld 4504 P/N.560644-01 GB 1907 IN...