Idle Speed Adjustment; Before Operation - Bushranger MC-PX-2 Owner's/Operator's Manual

Idle Speed Adjustment

This Multi-cutter is equipped with non-adjustable fuel mixture carburetor. The idle speed is the only adjust-
ment for the operator.
Please see your Multi-Cutter Power Unit Owner's/Operator's Manual.
POTENTIAL HAZARD
・ Engine must be running to make carburetor adjustments.
・ When engine is running, attached tool and other parts are moving.
WHAT CAN HAPPEN
・ Contact with moving attached tool or other moving parts could cause serious personal injury or
death.
HOW TO AVOID THE HAZARD
・ Keep hands, feet and clothing away from attached tool and other moving parts.
・ Keep all bystanders and pets away from unit while making carburetor adjustments.
The cutting attachment may be rotating during idle speed adjustment. Wear the recommended
personal protective equipment and observe all safety instructions. Keep hands and body away
from the cutting attachment.
If idle speed adjustment is necessary, and after adjustment the cutting attachment rotates or the
engine stalls, stop using the Multi-cutter immediately!
Contact your local authorized BUSHRANGER Dealer for assistance and servicing.

Before Operation

Chain Oil
1) Adding oil
1. Remove the oil tank cap and pour the chain oil (SAE
#10W-30) into the oil tank.
2. Once the oil has been poured into the oil tank, tighten the
oil tank cap to securely close the tank.
・ Ensure that the guide bar and saw chain are installed on the pruner before verifying the
discharging rate of the chain oil. The rotator will be exposed and therefore dangerous if the
guide bar and the saw chain are not installed on the pruner.
・ It may take some time before the oil begins to discharge once the oil has been added to a new
product or when oil has been added to an empty tank. Do not turn the pruner on at a high speed in
such circumstances.
• When a new chain is to be used, immerse the chain in chain oil for some time prior to installing
it on the pruner, or pour the oil directly on to the chain and the guide bar, after installing it on the
pruner. If they are not properly lubricated with oil the pruner may seize.
WARNING
DANGER
CAUTION
＿ 7 ＿
Oil tank cap
Oil tank