Easylink - Brickcom Fixed Box FB-100A User Manual

TM

EasyLink

EasyLink is a unique Brickcom function which allows users to assign a unique domain
TM
name to their network camera's IP address. There is no need to configure the router to
open up ports or remember hard-to-memorize IP addresses.
enabled, users can log onto [uniquedomainname].mybrickcom.com to view the camera's
web GUI and live view.
1. Check the box to enable EasyLink
2. Enter a unique domain name whose length must be between 5-32 characters.
Verify that the domain name is available.
3. Select a desired amount of time from the Refresh Time drop-down menu to confirm
the connection status.
Click Apply to apply settings or Cancel to cancel changes.
NOTE - The EasyLink function will not work if the following conditions occur:
1. The camera cannot be located behind a double NAT network.
2. The camera's IP address cannot be assigned to specific port numbers using the
router's port forwarding.
3. EasyLink uses UPnP to exchange port information with the router. The camera
must connect to the internet through a router which supports UPnP.
TM
.
49
When this function is