Table of Contents
Advertisement
Operation
Master/Slave Mode
The Master/Slave mode allows a single Ovation FD-105WW (the "master") to control the actions of one or
more Ovation FD-105WW products (the "slaves") without the need of a DMX controller to control the
slaves. The master will be set to operate in Master mode (MAST), while the slaves will be set to operate in
Slave mode (SLAVE). Once set and connected, the slaves will operate in unison with the master.
To set each of the slaves:
1.
Go to the RUN MODE main level.
2.
Select SLAVE.
3.
Connect the DMX input of the first slave to the DMX output of the master.
4.
Connect the DMX input of the subsequent slaves to the DMX output of the previous slave
5.
Finish setting and connecting all the slaves
To set the master:
1.
Go to the SETTING main level
2.
Select MODE SETTING.
3.
Select MAST.
•
Note: If you select SELF, no DMX signals are sent to the slaves.
4.
Make the master the first product in the DMX daisy chain.
5.
Control the master using the DMX controller and the slaves will operate in unison.
•
The master is the one that runs a program in Static mode.
•
Do not connect a DMX controller to the products configured for Master/Slave
operation. The DMX controller may interfere with signals from the master.
•
The master should be the first product in the daisy chain.
Factory Reset
This option restores the Ovation FD-105WW to factory default settings.
1.
Go to the SETTING main level.
2.
Select RESET.
3.
Enter the passcode and press ENTER to reset the product to its factory settings.
LED Frequency
This option changes the Pulse Width Modulation (PWM) frequency of the LEDs on the Ovation FD-
105WW.
1.
Go to the SETTING main level.
2.
Select PWM.
3.
Select PWM Frequency (600Hz, 1200Hz, 2000Hz, 4000Hz, 6000Hz, or 25Khz).
Power Performance Output Options
The Ovation FD-105WW offers two power output options during the cooling of the fixture's LEDs.
1.
Go to the SETTING main level.
2.
Select PERFORM.
•
Select LIVE to cool the LEDs by balancing the use of the fan and the power output level.
•
Select STUDIO to cool the LEDs by maintaining the use of the fan and limiting the power
output level.
System Information
This option displays the total number of hours the product has run, the installed software version, and the
product's UID.
1.
Go to the INFORMATION main level.
2.
Select VERSION or RDM, and the product version, UID, or label will be displayed.
Ovation FD-105WW User Manual Rev. 4
Page 13 of 18
Advertisement
Table of Contents
