Table of Contents
Advertisement
Setup
Master/Slave Connectivity
The Master/Slave mode allows a Ovation FD-105WW (the master) to control one or more Ovation FD-
105WW products (the slaves) without a DMX controller. One Ovation FD-105WW becomes the master
when running an auto or custom program, or by being in a Static mode.
You must configure each slave's control panel to operate in Slave mode. During Master/Slave operation,
the slaves will operate in unison with the master.
DO NOT connect a DMX controller to products operating in Master/Slave mode. The
DMX controller signals may interfere with the signals from the master.
•
The
configure the master and slaves.
•
If you are not familiar with DMX standards or Master/Slave connectivity,
download the DMX Primer from the Chauvet website
www.chauvetprofessional.com
Dimmer Modes
The Ovation FD-105WW may be plugged into and controlled using a regular dimmer.
•
When in SENS mode, advanced onboard electronics automatically detect what type of power and
data the product receives and it responds accordingly. This is the factory default setting.
•
When in DMX mode, the product runs only on constant power and is controlled solely on DMX. The
product will not respond to dimmer control in this mode.
•
When in DMMR mode, DMX control is turned off. Intensity is controlled using a dimmer. In this
mode, the product reacts exactly like an incandescent product.
For the best performance while running on dimmers, use the settings listed below:
1.
Go to the SETTING main level.
2.
Select the DIMMER programming level.
3.
Select DIM4.
4.
Go back to SETTING main level.
5.
Select the CURVE programming level.
6.
Select CURVE3.
Mounting
Before mounting the product, read and follow the safety recommendations indicated in the Safety Notes.
For our CHAUVET Professional line of mounting clamps, go to http://trusst.com/products/.
Orientation
Always mount this product in a safe position, making sure there is adequate room for ventilation,
configuration, and maintenance.
Rigging
Chauvet recommends using the following general guidelines when mounting this product.
•
Before deciding on a location for the product, make sure there is easy access to the product for
maintenance and programming purposes.
•
Make sure that the structure onto which you are mounting the product can support the product's
weight. See the
Technical Specifications
•
When mounting the product overhead, always use a safety cable. Mount the product securely to a
rigging point, whether an elevated platform or a truss.
•
When rigging the product onto a truss, use a mounting clamp of appropriate weight capacity.
•
When power linking multiple products, mount the products close enough for power linking cables to
reach.
•
The bracket adjustment knobs allow for directional adjustment when aiming the product to the
desired angle. Only loosen or tighten the bracket knobs manually. Using tools could damage the
knobs.
Ovation FD-105WW User Manual Rev. 4
Operation
section of this manual provides detailed instructions on how to
for weight information.
for more information.
Page 7 of 18
Advertisement
Table of Contents
