Connect the cable to J3 and J4 on the system board. The USB port
cables can be inserted only if pin 1 of the cable (red wire) is aligned
with pin 1 of J3 and J4. Pin 5 of J3 has been removed and the hole in
the USB cable connector, which corresponds to pin 5, has been
plugged to prevent incorrectly inserting the connector.
Note:
Make sure " USB Controller" in the Integrated Peripherals setup of the
Award BIOS is Enabled.
USB port cables (optional)
Installing Expansion Cards
The 586IHX system board is equipped with 3 dedicated PCI slots, 3
dedicated 16-bit ISA slots and 1 shared PCI/ISA slot. All PCI slots are
bus masters. Refer to page 12 for the locations of the expansion slots.
28