System Memory - DFI 586IHX User Manual

System Memory

The SIMM (Single In-line Memory Module) sockets are divided into two
banks on the system board, Bank 0 and Bank 1. Each bank consists of
2 SIMM sockets. Refer to page 12 for the locations of the SIMM sockets.
You will need either 2 or 4 pieces of SIM modules, depending on the
amount of memory you intend to install. Make sure you insert the same
type of SIMMs in one bank. You can install SIMMs in either of the
banks, Bank 0 or Bank 1, but you must populate one bank first before
going to the next bank.
The 586IHX system board can support 8MB to 256MB of memory using
1MBx32/x36, 2MBx32/x36, 4MBx32/x36, 8MBx32/x36, or 16MBx32/x36
72-pin SIMMs. The table below shows the supported SIM modules and
their corresponding memory sizes.
1MBx32/x36
2MBx32/x36
4MBx32/x36
8MBx32/x36
16MBx32/x36
The table below summarizes the bank locations and modules needed
for the corresponding memory sizes.
Memory Size SIMM3
8MB 1MBx32/x36
8MB
2MBx32/x36
16MB
16MB
1MBx32/x36
16MB
24MB 1MBx32/x36
24MB 2MBx32/x36
SIMMs Memory Size
4MB
8MB
16MB
32MB
64MB
Bank 0
SIMM4
1MBx32/x36
—
—
2MBx32/x36
—
—
1MBx32/x36
1MBx32/x36
2MBx32/x36
Bank 1
SIMM1 SIMM2
—
—
1MBx32/x36
1MBx32/x36
— —
2MBx32/x36
2MBx32/x36
1MBx32/x36 1MBx32/x36
2MBx32/x36 2MBx32/x36
1MBx32/x36 1MBx32/x36
13