Table of Contents
Advertisement
PM Control by APM
Yes
An Advanced Power Management device will be activated to
enhance the Max. Power Saving mode and stop the CPU' s
internal clock. Use this option in Windows 95. (default)
N o
The system BIOS will ignore APM when initiating the Power
Management mode.
Video Off Method
This determines the manner in which the monitor is blanked.
V/H
This selection will cause the system to turn off the vertical and
SYNC +
horizontal synchronization ports and write blanks to the video
Blank
buffer.
Blank
This option only writes blanks to the video buffer.
Screen
DPMS
Initializes display power management signaling. Use this option
if your video board supports it.
MODEM Use IRQ
This category is used to set an IRQ channel (IRQ 3, 4, 5, 7, 9, 10 or
11) for the modem installed in your system.
Doze Mode, Standby Mode, Suspend Mode and HDD Power Down
These Green PC power saving categories are user configurable only
when the Power Management category is set to User Defined.
Doze
When enabled and after the set time of system inactivity, the
Mode
CPU clock will run at a slower speed while all other devices
still operate at full speed.
Standby
When enabled and after the set time of system inactivity, the
Mode
fixed disk drive and the video will be shut off while all other
devices still operate at full speed.
Suspend
When enabled and after the set time of system inactivity, all
Mode
devices except the CPU will be shut off.
40
Advertisement
Table of Contents
