Load Bios Defaults; Load Setup Defaults - DFI C586VX/E User Manual

PCI IDE IRQ Map To
This category is used to configure your system to the type of IDE disk
controller in use.
ISA Designates which ISA slot is installed with an IDE controller
card; that is, if you are using an IDE controller card.
PCI-Auto
The system will scan and determine the PCI slot that is in-
stalled with an IDE controller card.
Primary IDE INT# and Secondary IDE INT#
The Primary and Secondary IDE INT# categories are used to select the
PCI interrupt (A, B, C, or D) that is associated with the connected hard
drives.

Load BIOS Defaults

The " Load BIOS Defaults" option loads the troubleshooting default val-
ues permanently stored in the ROM chips. These settings are not opti-
mal and turn off all high performance features. You should use these
values only if you have hardware problems. Highlight this option on the
main menu and press <Enter>. The message below will appear.
Load BIOS Defaults (Y/N)? N
If you want to proceed, type <Y> and press <Enter>. The default set-
tings will be loaded.

Load Setup Defaults

The " Load Setup Defaults" option loads optimized settings from the
BIOS ROM. Use the Setup default values as standard values for your
system.
Highlight this option on the main menu and press <Enter>. The mes-
sage below will appear.
Load Setup Defaults (Y/N)? N
Type <Y> and press <Enter> to load the Setup default values.
35