Table of Contents
Advertisement
1.7 Panel Mounting
There is an adhesive waterproof gasket on the A-Mg front bezel. Make
sure the waterproof gasket is in position before installing the TPC-60 into
the panel opening.
1.
Install the TPC-60 to the panel opening.
2.
Find the eight clampers and eight long screws in the accessory
pack. Hook these clampers to the holes around the four sides of the
bezel. Insert the screws into every clamper and fasten them. These
screws will then push the mounting panel and fix the unit. The
mounting panel thickness is suggested to be less than 6 mm (0.236
inch).
TPC-60S User Manual
Figure 1.2: Panel Mounting
6
Advertisement
Table of Contents
